Well like I said I could pick it up and you could swing by my place or I could meet you somewhere.
I'll see if anyone recommends a shop down here if they don't then I'll give Toledo a call. A drive to Boulder isn't too bad.
Smoothing the edges is not a problem just takes some wet-sand paper and a little elbow grease. However 3/8" is too thick to do yourself. It would
Needs to 3/8" and I'd rather have it done so the edges a smooth not sharp.
how thick? you could probably do it yourself its not very hard.
Otherwise Toledo glass is good but unfortunately in Boulder. If you don't
Anybody know a good reasonably priced shop to get a piece of glass to use as the center brace on the 180? Prefer Denver or Aurora.