Need a new cabinet door hinge hole cut out, where do they do this at?

[opakapaka]

It looks like a 1 1/2" inch hole cut out prob about 1/2" deep.

 

[opakapaka]

 

[jahmic]

You just need something like a 1 1/2" spade bit for a drill....looks like this:

http://www.homedepot.com/p/Bosch-1-1-2-in-x-6-in-DareDevil-Spade-Bit-DSB1021/203274564

 

[Craigar]

If its , a cabinet door they make a special bit for it I have one

 

[SkyShark]

That hole looks like it was cut with a forstner bit. You can use it in most drills. You can buy single bits on amazon or Home Depot, but Rockler has the best selection.
A spade bit could work if the wood is thick enough, but it is probably too aggressive for what you are wanting.

 

[opakapaka]

would something like this work, if i can find the right diameter?
http://www.homedepot.com/p/Ryobi-Forstner-Bit-Set-8-Piece-A9FS8R1/202078676

 

[Craigar]

http://m.homedepot.com/p/Liberty-1-3-8-in-Hinge-Installation-Template-AN0192C-G-Q1/202280214/

This is most likely what you need

 

[opakapaka]

Thanks guys

 

[jahmic]

Good call on the forstner bit...couldn't for the life of me remember what those were called and I def agree that'd work better The spade probably won't give you a flush base

 

[Cabby]

I have a boring machine that will bore that exact pattern. Bring it by my shop.
PM for directions

 

[Aaron]

I had the same problem with my cabinets. A dremel worked great. I used the sanding bit to enlarge the holes.

 

[opakapaka]

http://m.homedepot.com/p/Liberty-1-3-8-in-Hinge-Installation-Template-AN0192C-G-Q1/202280214/

This is most likely what you need

Wife was nagging too much dso I went out and got this, worked like a charm...thanks Craig.